OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P21FE

Fuel Control System B Too Lean at Higher Load (Bank 2)

P21FE is the bank 2 counterpart of P21FC: in the upper load zone the second injection path on bank 2 needs more enrichment than its adaptation may supply. It can only appear on two-bank engines with per-bank sensors and dual injection. No manufacturer documents it publicly, and Ford, which uses port plus direct injection on V engines such as the 5.0 Coyote from 2018, reports port-side lean faults per bank as P2BF2 without load cells. If only bank 2 is lean at high load, suspect restricted port injectors or harness trouble on that bank; if both banks set high-load lean codes, the supply side they share is more likely, for example the lift pump, the filter or the low-pressure sensor. A loss of pull at full throttle may be felt. P2193 belongs to system A.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / FE

Possible causes

  • Restricted port injectors on bank 2 medium
  • Harness or connector fault on bank 2 injectors low
  • Weak shared supply (lift pump, filter, low-pressure sensor) if both banks lean medium

Symptoms

  • Check engine lamp on
  • Loss of pull at full throttle

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P21FE

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication