P21F5
Fuel Control System B Too Rich Off Idle (Bank 1)
P21F5 is the rich limit for the second fuel path of bank 1 in the part-load zone above idle: the learned correction already removes as much fuel as allowed, yet the front sensor still sees surplus fuel. Audi lists the code for the 2.5 TFSI in the 2017 to 2018 RS 3 and TT RS, whose manifold injectors run on a 7 bar rail beside the high-pressure system, and cures it by reprogramming the engine control module (bulletin 2059429/1). In other cases, a port injector that leaks or opens too long, excessive pressure in the low-pressure rail or an air mass reading that is too high are typical. An FCA patent for such engines clears a mode-specific fault only after the monitor passes again in the same injection mode. Expect higher consumption; P2178 is the system A partner.
Possible causes
- Outdated engine control software (Audi 2.5 TFSI, bulletin 2059429/1) high
- Port injector on bank 1 leaking or sticking open medium
- Pressure in the low-pressure rail above specification low
- Air mass sensor reading too high low
Symptoms
- Check engine lamp on
- Increased fuel consumption
- Fuel smell from the exhaust
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P21F5
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.