OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P21F1

Cylinder 11 Injector B Circuit High

P21F1 describes a cylinder 11 B injector circuit that sits too high, i.e. its switched side is shorted to supply. The code exists in SAE J2012 for completeness of the cylinder series, but no public manufacturer source uses it, and no twelve-cylinder engine with two injectors per cylinder could be documented. CARB still requires an emission-relevant output to be checked for circuit faults, while allowing makers to combine fault types; a system could therefore report this short under the open code P21D9 instead. Electrically, a short to power keeps the injector from opening and loads the driver each time it switches. GM's LT5 V8 shows typical criteria for the same fault type, 0.5 Ohm or less to power in the driver-off state, Type A. Low fault: P21F0; A injector high: P0292.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / F1

Possible causes

  • Control wire of the cylinder 11 B injector shorted to power high
  • Injector coil shorted medium
  • Control module driver damaged low

Symptoms

  • Check engine light on
  • Cylinder 11 lean or misfiring (P0311)

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P21F1

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication