OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P21EC

Cylinder 9 Injector B Circuit Low

P21EC signals a low circuit state, usually a grounded wire or, depending on the maker, also a break, on the B injector of cylinder 9. It can only occur on an engine with at least nine cylinders and two injectors per cylinder. No manufacturer documents it publicly; GM's and Ford's lists stop at cylinder 8. The one such engine on record is Lamborghini's Huracán V10, which combines direct and multi-point injection; which of the two it calls B is not published. Its firing order alternates between cylinders 1 to 5 and 6 to 10, so cylinder 9 belongs to the second bank. CARB requires circuit monitoring of such output components. By analogy with GM's V8, a ground below about 0.5 Ohm on the switched-off low side would count. Open circuit: P21D7; high fault: P21ED.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / EC

Possible causes

  • Cylinder 9 B injector wire shorted to ground high
  • Broken wire, if the maker reports opens under the low code medium
  • Injector coil shorted to housing or open medium
  • Engine control module output faulty low

Symptoms

  • Check engine light on
  • Misfire or rough running on cylinder 9
  • Mixture deviation on the bank of cylinder 9

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P21EC

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication