OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P21EB

Cylinder 8 Injector B Circuit High

P21EB is set when the cylinder 8 B injector circuit is shorted toward power. It closes GM's run of B-injector codes for the 2019 Corvette ZR1 LT5: the FICM sees the switched-off low side within 0.5 Ohm of supply in 20 of 25 samples and stores a Type A fault, lighting the MIL in the first trip. The supplemental injector of the right-rear cylinder can then no longer be opened, while the direct injector keeps working, so the car usually drives normally until high boost, where bank 2 may lean out. If several of these high codes appear together, a common feed or a shared connector is more likely than eight bad injectors. P21EA is the matching low fault, P0283 the A injector high fault and P0308 the misfire counter of this cylinder.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / EB

Possible causes

  • Cylinder 8 B injector control wire shorted to a feed wire high
  • Shared harness connector shorted when several injectors are affected medium
  • Injector coil shorted medium
  • Injection control module damaged low

Symptoms

  • Check engine light on
  • Lean bank 2 under boost
  • Normal behaviour at part load

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P21EB

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication