P21E9
Cylinder 7 Injector B Circuit High
P21E9 indicates that the low side of the cylinder 7 B injector carries supply voltage. On GM's 2019 Corvette ZR1 LT5, the FICM declares this when it sees 0.5 Ohm or less to power with the driver off, provided the engine runs and the powertrain relay delivers 11 V or more; Type A, one trip. The rear left cylinder then gets only its direct injector. As the extra port fuel on this engine is meant for boosted operation, the effect may be limited to full throttle, where bank 1 can turn lean. CARB demands that output components be checked for circuit faults, yet leaves it to the maker whether shorts to power get their own code; GM separates them, while Ford folds every B-injector short into the open code (here P21D5). Low fault: P21E8; A injector high: P0280.
Possible causes
- Cylinder 7 B injector control wire shorted to battery voltage high
- Injector coil with too low resistance medium
- Injection control module driver defective low
Symptoms
- Check engine light on
- Bank 1 lean at full throttle
- Less power at full throttle
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P21E9
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.