OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P21E5

Cylinder 5 Injector B Circuit High

P21E5 means the cylinder 5 B injector circuit is pulled toward supply voltage. GM documents it for the LT5 V8 of the 2019 Corvette ZR1: the FICM looks at the low side of that injector while its driver is off and treats 0.5 Ohm or less toward power as a short. The test needs a running engine and at least 11 V at the powertrain relay, runs continuously and sets a Type A fault. A low side held at supply potential can never be switched to ground, so the injector stays closed. On this engine the port injectors were added mainly to supply extra fuel under boost, so a dead unit tends to show at high load, where cylinder 5 may run lean. The low-side counterpart is P21E4; the A injector of the same cylinder reports P0274 for the same fault type.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / E5

Possible causes

  • Low-side wire of the cylinder 5 B injector shorted to a supply wire high
  • Supply and control wire of the injector bridged in the harness medium
  • Injector coil shorted across its terminals medium
  • Damaged output stage in the injection control module low

Symptoms

  • Check engine light on
  • Cylinder 5 lean or hesitant at full load
  • Part-load driving often feels normal

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P21E5

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication