OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P21DE

Cylinder 2 Injector B Circuit Low

P21DE is the low fault of the cylinder 2 B injector circuit. In Mitsubishi's 2022 Eclipse Cross manual, B means the direct injector; the code covers both a break and a grounded wire on the two DI lines of cylinder 2, held for 2 s at 10 to 16.5 V, while the port injector of the same cylinder reports P0264. Diagnosis starts with the coil resistance at the intermediate connector, which should be 1.74 to 2.04 Ohm at 20 °C. On GM's 2019 LT5 V8 cylinder 2 is the front cylinder of the right bank; there a low side shorted to ground on the supplemental injector, below 0.5 Ohm, sets a Type A fault from its separate module. GM runs this check while the driver is switched off; a grounded low side can energise the injector without a command. P21DF is the high fault, P21D0 the open.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / DE

Possible causes

  • Injector line of cylinder 2 touching ground high
  • Injector coil resistance outside specification medium
  • Fault at the intermediate connector of the injector harness medium

Symptoms

  • Check engine light on
  • Misfire on cylinder 2 (P0302)
  • Possible fuel smell or rich running if an injector stays open

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P21DE

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication