OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P21D6

Cylinder 8 Injector B Circuit/Open

P21D6 is the highest B injector code that any manufacturer documents publicly: both Ford's port injector check (P21CF to P21D6) and GM's LT5 injection module list end here. On the LT5 the port injectors exist to add fuel under boost beyond what the direct system and its mechanical pump can deliver, so an open cylinder 8 injector shows up mainly at high load, where that cylinder can run lean and lose power; GM stores the fault as Type A from 20 failed samples out of 25 with at least 11 V on the powertrain relay. In GM's firing order cylinder 8 follows cylinder 1. On Ford's 5.0 V8 from 2018 it is the rear cylinder of the second bank and the check runs continuously for 5 s. The direct injector counterpart is P0208; P21D5 is cylinder 7.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / D6

Possible causes

  • Port injector of cylinder 8 open high
  • Wire damage at the rear of the engine near the firewall medium
  • Output of the engine or separate injection module failed low

Symptoms

  • Check engine light on
  • Misfire or lean running on cylinder 8 under load
  • Power loss at wide-open throttle

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P21D6

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication