P21BC
Cold Start Cylinder 7 Injection Timing
From cylinder 7 on, the code is limited to engines with at least seven cylinders – in practice V8, V10, V12 and W12. Common petrol V8 with direct injection are GM's 5.3- and 6.2-litre small blocks, which a GM bulletin describes with dual-pulse injection after a cold start, and Ford's 5.0-litre Coyote, which since 2018 combines port and direct injection. P21BC reports that during the cold-start heating phase the injection timing of cylinder 7 missed its target; on dual-system engines the direct injector is the part whose timing is shifted. No manufacturer publishes use of P21BC. If the code repeats on cylinder 7 only, test that injector cold and compare it with the others. Related: P021A (warm), P2B0E (cold-start pulse), P0207, P0307.
Possible causes
- Direct injector of cylinder 7 slow to open or leaking at low temperature high
- Chafed or heat-damaged wiring to injector 7 medium
- Fault in the high-voltage injector driver of the engine module low
Symptoms
- Check engine light after cold starts
- Rough cold idle, sometimes with P050D or a cylinder 7 misfire code
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P21BC
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.