OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P21B8

Cold Start Cylinder 3 Injection Timing

Cylinder 3 is the last cylinder of three-cylinder engines such as Ford's 1.0-litre EcoBoost, a turbo direct-injection unit. There a single cylinder accounts for a third of all combustion events, so a cold-start fault on it tends to be felt more than on larger engines. P21B8 reports that while the cold-start heating strategy was active, the injection timing of cylinder 3 left its tolerance. The code belongs to a per-cylinder series made necessary by CARB's demand to keep cold-start faults apart from warm-running faults; no manufacturer documents its use publicly. On engines with four or more cylinders P21B8 simply marks cylinder 3. Neighbouring checks: P020C for the warm engine, P2B0A for the cold-start injection pulse, P0303 for misfire.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / B8

Possible causes

  • Injector of cylinder 3 with deposits or a weak coil high
  • Moisture or corrosion in the plug of injector 3 medium
  • Engine software update available for the cold-start calibration low

Symptoms

  • Noticeable shaking at cold idle, especially on three-cylinder engines
  • Check engine light after cold starts
  • Normal running once warm

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P21B8

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication