P21B5
NOx Adsorber - Over Temperature (Bank 2)
P21B5 is the bank 2 version of the adsorber over-temperature fault and therefore only exists where each cylinder bank feeds its own NOx storage catalyst, which in practice means V engines with two exhaust paths. If only bank 2 overheats, the cause most likely sits on that side: an injector delivering too much, misfire limited to that bank, or a faulty temperature sensor there. If P21B4 is stored as well, look instead for something both banks share, such as the regeneration strategy, fuel quality or a skewed air mass reading. Eaton patent US7251929 puts the ageing limit near 750 °C during desulphation. No manufacturer publishes its P21B5 limit; the duty to monitor adsorber performance comes from CARB (13 CCR 1968.2 (f)(8)). Driving on risks permanent damage.
Possible causes
- Injector on bank 2 delivering too much fuel high
- Misfire confined to bank 2 medium
- Regeneration overheating both banks (with P21B4) medium
- Bank 2 exhaust temperature sensor reading too high low
Symptoms
- Check engine light on
- Reduced power to protect the catalyst
- Uneven exhaust temperatures between the banks
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P21B5
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.