OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P219E

Cylinder 3 Air-Fuel Ratio Imbalance

P219E points at cylinder 3. Two bulletins show that a mixture code does not always mean a fuel part. Audi stored P219C to P21A1, one code per affected cylinder, on 2010 to 2012 S4, S5 and A6 with the 3.0 TFSI because of an incorrect software setting; the fix was new engine software and, in a later revision, a new crankcase pressure regulating valve. Lexus traced P219A and P219C to P219F on the 2.0 turbo 8AR-FTS (NX, IS, RC, GS 2015 onward) to compression lost through exhaust valves with worn guides, sometimes with misfire codes and reduced engine power, and repaired the cylinder head. Toyota's 2015 Tacoma V6 bulletin also starts with a leak-down test. For a lone P219E, test the cylinder 3 injector and compression before replacing sensors; the bank sensor itself is shared by all cylinders.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / 9E

Possible causes

  • Exhaust valve leakage at cylinder 3 (e.g. worn guides on Lexus 8AR-FTS) medium
  • Cylinder 3 injector delivering the wrong amount medium
  • Incorrect ECM software setting (e.g. Audi 3.0 TFSI) medium
  • Faulty crankcase pressure regulating valve low

Symptoms

  • Check engine light on
  • Possible P0303 or rough running
  • Reduced engine power in severe cases

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P219E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication