OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P219A

Bank 1 Air-Fuel Ratio Imbalance

P219A means the ECM sees mixture differences between the cylinders of bank 1 that are large enough to raise emissions, even if the bank average is fine. CARB phased this monitor in from 25 % of 2011 to all 2014 model-year petrol vehicles (13 CCR 1968.2 (e)(6.2.1)(C)). GM measures how much the upstream sensor signal varies per firing event, normalises the result against a map of a healthy engine and flags a ratio above 1.05 (one 2016 engine, 1100 to 3500 rpm, Type A, one trip). Mitsubishi counts rich and lean peaks at 1750 to 3250 rpm and 40 to 70 % volumetric efficiency. On inline engines bank 1 is the whole engine. Toyota traced P219A on 2012 to 2014 Corolla 2ZR engines to compression escaping into the exhaust; from 2014 the Corolla adds the cylinder codes P219C to P219F.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / 9A

Possible causes

  • One injector clogged, leaking or out of flow tolerance high
  • Compression loss through an intake or exhaust valve medium
  • Air leak at one intake runner or gasket medium
  • ECM logic or sensor signal issue covered by software or wiring bulletins low

Symptoms

  • Check engine light on
  • Often no noticeable symptom
  • Slight rough running or misfire codes when one cylinder is far off

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P219A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication