P2199
Intake Air Temperature Sensor 1/2 Correlation
P2199 compares two intake air temperature readings that should be close, typically one in the air mass sensor and one further downstream in the intake manifold or a combined pressure and temperature sensor. Each circuit can be fine on its own; the fault is the disagreement. GM sets it when the two values differ by more than 55 °C in 40 of 50 samples taken every 100 ms, as a Type B code with MIL after two trips (2016 and 2018 tables). VW's 2014 Touareg uses a much tighter limit of 10 °C between the two manifold temperatures. CARB requires such rationality checks for input sensors under (e)(15). Stellantis lists it among the codes addressed by a PCM update for the 2020 RAM 1500 with the 3.0 EcoDiesel V6; there, check the software level first. Circuit faults are P0111 to P0114 (sensor 1) and P0096 to P0099 (sensor 2).
Possible causes
- One temperature sensor drifted or contaminated high
- Corroded connector or added resistance in one sensor circuit medium
- Calibration issue fixed by a PCM update (e.g. RAM 1500 3.0 EcoDiesel 2020) medium
- Strong heat soak or hot-air leak near one sensor low
Symptoms
- Check engine light on
- Usually no noticeable driveability change
- Scan data shows two clearly different intake temperatures with the engine cold-soaked
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P2199
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.