OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2198

O2 Sensor Signal Biased/Stuck Rich (Bank 2, Sensor 1)

P2198 is the bank 2 counterpart of P2196: the bank 2 front oxygen or A/F sensor reports rich in a way the ECM does not accept. On GM's Bosch-based 2005 2.8 and 3.6 V6 the bank 2 rear sensor must read lean (below 0.15 V) while the front sensor reads richer than lambda 0.92 and the short-term trim has dropped to its 0.75 minimum; the code then sets after about 100 s, or 50 s cumulatively, over two trips. Ford uses the same lack-of-switching, trim-limit and stuck-lambda logic as on bank 1, sets the stuck-rich code when the frozen lambda value is below 1, and suspends the stuck-rich test during cold starts while fuel boils off the oil through the crankcase ventilation. A sensor contaminated by oil or coolant, or one whose signal or reference wiring has a fault, gives this pattern; since the ECM leans bank 2 to follow the false reading, the rear sensor of that bank usually shows lean at the same time.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / 98

Possible causes

  • Bank 2 front oxygen or A/F sensor contaminated or aged high
  • Sensor signal or reference wiring fault low

Symptoms

  • Malfunction indicator lamp on
  • Possible hesitation or lean running

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2198

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication