P2194
System Too Rich at Higher Load (Bank 2)
P2194 means bank 2 has reached the lower limit of its trim in the upper load zone: the ECM is removing as much fuel as permitted, yet that bank still runs rich. Because air mass, fuel pressure and canister purge feed both banks, a rich error caused by them usually brings P2192 along. When P2194 stands alone, look at bank 2 itself: a leaking or over-delivering injector, an injector of the wrong flow class after a repair, or a bank 2 front sensor that reads lean so the controller keeps adding fuel. Comparing the trims of both banks while holding a high load on the road or a dynamometer separates the two cases. No manufacturer publishes P2194 criteria; GM uses P2180 with a factor limit of 0.78 for the corresponding range. The driver mainly sees higher consumption.
Possible causes
- Leaking or over-delivering injector on bank 2 high
- Bank 2 front sensor reading lean medium
- Air mass sensor reading high or fuel pressure too high (usually with P2192) medium
Symptoms
- Check engine light on
- Increased fuel consumption
- Bank 2 long-term trim strongly negative at high load
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2194
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.