P2193
System Too Lean at Higher Load (Bank 2)
P2193 reports for bank 2 what P2191 reports for bank 1: in the upper load zone the long-term trim of that bank sits at its enrichment limit. It only exists on engines with a separate front sensor per bank, such as V6, V8 and boxer engines. The useful question is whether bank 1 shows the same. Lean at high load on both banks (P2191 with P2193) points to something they share, chiefly fuel pump, filter, pressure regulation or the air mass sensor. Bank 2 alone narrows it to that side: injectors on bank 2, an intake gasket or runner leak there, or an exhaust leak ahead of the bank 2 sensor. No manufacturer documents P2193 publicly; GM monitors the comparable range as P2179, and CARB sets the general rule for exhausted fuel adaptation in 13 CCR 1968.2 (e)(6.2.2).
Possible causes
- Weak fuel supply (pump, filter, pressure regulation), usually with P2191 high
- Restricted injectors on bank 2 medium
- Intake gasket or runner leak on the bank 2 side medium
- Exhaust leak ahead of the bank 2 front sensor low
Symptoms
- Check engine light on
- Hesitation under heavy acceleration
- Bank 2 long-term trim much higher than bank 1 at high load
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2193
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.