OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P218D

Throttle/Fuel Inhibit B Circuit Low

P218D reports that the voltage on inhibit line B sits below the lowest permitted value, which normally points to a short to ground, a missing supply from the sending unit or an open line pulled down by the input stage. No manufacturer documents P218D publicly. For the A line, GM's 2005 table for the 3.5-litre V6 (L66) gives a concrete limit: P2554 is set when the analogue throttle inhibit circuit reads under 0.498 V for 4 seconds, with the check running after ignition off and the MIL lit on the next drive cycle. California's OBD rule requires out-of-range checks on such inputs. Chafed insulation touching body ground, water in a connector or a failed driver in the sending module are the likely causes. P218E is the opposite fault, P218B the general circuit code.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / 8D

Possible causes

  • Inhibit B wire shorted to ground high
  • Water or corrosion in a connector of the inhibit line medium
  • Output stage of the sending module failed low

Symptoms

  • Check engine lamp on the following drive
  • Possible power reduction

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P218D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication