OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P218B

Throttle/Fuel Inhibit B Circuit

P218B is a general electrical fault in the second throttle/fuel inhibit line, B. An inhibit line carries a signal with which another unit can tell the engine computer to keep the throttle closed or stop fuelling. No manufacturer documents the B line publicly. The only published use of this function concerns the A line: GM's 2005 table for the 3.5-litre V6 (L66) places it in the throttle valve control section, where the injection and throttle processors check each other, and monitors it with P2553-P2555 once per drive cycle after ignition off, lighting the MIL on the next drive cycle. California's OBD rule requires inputs of this kind to be checked for circuit faults. Open wires, corroded pins and module connector faults come first; reduced power is possible.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / 8B

Possible causes

  • Open or high-resistance inhibit B wire high
  • Corroded or loose pins at the engine or throttle module connector medium
  • Fault in the unit that drives the inhibit signal low

Symptoms

  • Check engine lamp on the following drive
  • Possible power limitation

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P218B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication