OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P218A

Throttle Actuator B Control System - Idle Position Not Learned

P218A is the throttle B counterpart of P2176: on engines with a second electronic throttle, usually one per cylinder bank, that second unit failed to learn its closed rest position. GM's 2023 table 23OBDG07 runs the same three-step learn for bank 2 as for bank 1. First the plate must reach the closed target within 1.5 %, then the motor has to press it onto the stop with enough duty cycle, and finally the stored voltages must fall inside 0.33-0.58 V for sensor 1 and 4.42-4.67 V for sensor 2; any failed step stores the code within one trip. No other manufacturer documents P218A publicly. Ice, carbon, a weak motor or wiring faults at throttle B are typical causes, and engine power may be limited. Electrical motor faults of throttle B use P210A.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / 8A

Possible causes

  • Carbon or ice keeping throttle B off its closed stop high
  • Weak motor or gear wear in throttle unit B medium
  • Position sensors of throttle B outside the learn window medium
  • Supply or signal wiring fault at throttle B low

Symptoms

  • Check engine lamp
  • Uneven idle between the banks
  • Reduced power

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P218A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication