P2182
Engine Coolant Temperature Sensor 2 Circuit
P2182 is the general circuit code for the second coolant temperature sensor: the module sees a fault in its wiring or signal but does not sort it into low, high or erratic. Where sensor 2 sits is up to the maker. Mazda fits it low on the radiator, VW calls it the radiator outlet sender, Ford's Escape plug-in hybrid uses it in the cabin heater loop, GM uses a second engine sensor. No maker documents P2182 itself publicly; GM, VW and others report the same sensor through the more specific P2184 to P2186. CARB demands that every coolant sensor be tested for broken circuits and readings beyond its valid span. Likely causes are an open signal wire, a loose connector or a dead sensor. Depending on the use of the sensor, fan control, thermostat diagnosis or cabin heating may run on substitute values.
Possible causes
- Loose, corroded or water-damaged connector at sensor 2 high
- Signal or reference wire to sensor 2 open or damaged medium
- Sensor 2 itself defective medium
Symptoms
- Check engine light
- Radiator fan runs continuously as a precaution
- Thermostat or cooling diagnostics unavailable
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P2182
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.