P217F
Fuel Injector Group H Supply Voltage Circuit High
P217F is the last code of the injector group series: the feed of group H, cylinder 8 on GM's direct-injection V8 engines, shows supply voltage although the high-side driver is switched off. GM's tables 16OBDG07A, 18OBDG03A for the 6.2 LT4 and 19OBDG03A set it when the line stays within 1 V of the controller supply, counting 10 failures out of 20 samples at 100 ms with 11 V or more, type A, MIL on the first trip. A short to power can hold the injector partly open or stress the driver, so the module cuts cylinder 8. Wiring that touches a powered conductor, moisture in the plug or a failing module output are the candidates; high codes on several cylinders together suggest the module. P217E is the short to ground, P217D the general fault.
Possible causes
- Cylinder 8 feed shorted to a powered wire high
- Moisture or corrosion in the injector connector medium
- Engine control module output stage faulty low
Symptoms
- Check engine lamp on immediately
- Cylinder 8 misfire, possibly rich running on bank 2
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P217F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.