OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P217D

Fuel Injector Group H Supply Voltage Circuit/Open

Group H is the eighth injector group, on GM petrol direct injection the injector of cylinder 8, the last one on bank 2 of a V8. GM's 2023 and 2024 tables call it injector H and use P217D when its high side shows less than 0.5 ohm to ground with the driver off or to the injector supply with the driver on; two events above 9 V store the code in one trip. GM's service texts refer to it as the high control circuit of the cylinder 8 injector. Bulletin 24-NA-106 for the 2023 and 2024 Corvette with the 5.5 LT6 shows how a common cause hits a whole bank: water getting into a wrong twelve-pin intermediate connector to the bank 2 injector harness set P2149, P2155, P216D and P217D, the even cylinders, together with rail pressure codes. The fix is a connector with the correct part number.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / 7D

Possible causes

  • Water in the bank 2 injector harness connector, Corvette LT6 medium
  • Cylinder 8 injector feed shorted in the harness high
  • Cylinder 8 injector shorted internally low

Symptoms

  • Check engine lamp on, cylinder 8 misfire
  • Several bank 2 injector codes at once if the connector is wet

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P217D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication