OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P217B

Fuel Injector Group G Supply Voltage Circuit Low

P217B reports the feed of injector group G as grounded, which on GM's direct-injection V8 engines is the injector of cylinder 7, at the rear of bank 1. GM's 2016 table 16OBDG07A and the 2018 LT4 table of the supercharged 6.2 V8 measure it with the driver switched on: if 25 A or more flows through the high side, the line is grounded somewhere. The check runs every 100 ms as soon as the battery has 11 V; 10 failures in 20 samples set the code as type A, so the MIL comes on in the same trip. Check the harness routing at the rear of the engine and the injector connector before suspecting the module. The module stops firing the injector, which shows up as a cylinder 7 misfire. P217C is the high fault, P217A the general one.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / 7B

Possible causes

  • Cylinder 7 feed wire grounded at the rear of the engine high
  • Cylinder 7 injector shorted to ground medium
  • Engine control module output stage faulty low

Symptoms

  • Check engine lamp on immediately
  • Cylinder 7 misfire, reduced power

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P217B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication