OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2179

System Too Lean Off Idle (Bank 2)

P2179 is the bank 2 version of P2177 on engines with a front oxygen sensor for each cylinder bank: the load-dependent, multiplicative share of bank 2's long-term correction has reached its lean limit. GM's 2005 2.8 and 3.6 V6 and the 2008 3.6 LLT use a factor above 1.23, GM's 2024 tables above 1.27, both over two trips. VW's 2014 Touareg sets it for the 3.0 TSI hybrid and the 3.6 VR6 when bank 2 adaptation exceeds +30 %. If both banks are lean at load, look at what they share: fuel pressure, the pump, the air mass sensor. If bank 2 alone is affected, the cause lies on that side, such as a restricted injector, an intake leak at that bank's manifold or a front sensor reading lean. No bulletin naming this code was found.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / 79

Possible causes

  • Low fuel pressure or air mass sensor fault, usually with P2177 too medium
  • Restricted injector on bank 2 medium
  • Intake leak or front oxygen sensor fault on bank 2 medium

Symptoms

  • Check engine lamp on after two trips
  • Hesitation under load

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2179

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 5 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication