OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2178

System Too Rich Off Idle (Bank 1)

P2178 is the rich-side limit of the bank 1 load adaptation: above idle the long-term trim has to take away more fuel than allowed. GM's Bosch-based V6 engines of 2005 and 2008 set it below a factor of 0.78, the 2023 and 2024 tables below 0.77, each after two trips. Saab's 9-5 2.0T uses the same window as for the lean code, 6.9 to 41.7 g/s, 18 to 80 % load and 1280 to 4000 rpm, and wants 4 s without break or 50 s in total. VW's 2014 CC 2.0 TSI accepts down to -21 %. A rich error that grows with load usually means an air mass sensor reading too high, excessive fuel pressure or injectors delivering too much. Mercedes saw it on the M254 with fuel boiling in the low-pressure side; Jaguar Land Rover lists P2178 with P0191 on Ingenium petrol engines and cured it with new PCM calibration.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / 78

Possible causes

  • Air mass sensor reading too high medium
  • Fuel pressure too high or injectors over-delivering medium
  • Calibration error fixed by a software update medium
  • Fuel vapour from purge or boiling fuel in the low-pressure system low

Symptoms

  • Check engine lamp on after two trips
  • Higher fuel consumption, fuel smell

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2178

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication