P216F
Fuel Injector Group F Supply Voltage Circuit High
P216F is set when the group F supply, on GM petrol direct injection the high-side line of cylinder 6, shows voltage while the driver is off. GM's criterion in its 2016 (16OBDG07A) and 2018 LT4 tables is 1 V or less between the line and the controller supply, which means the wire is practically at battery level. At 11 V or more, 10 failures out of 20 samples at 100 ms store it as type A, MIL on the first trip. A short to power can keep current flowing through the injector or overload the driver, so the module disables that cylinder. Look for insulation damage where the harness meets brackets or the transmission, as described for the Impala in PI0631H, and for a connector bridged by moisture. Several high codes on different cylinders at once point to the module. P216E is the short to ground.
Possible causes
- Cylinder 6 feed shorted to another powered wire high
- Engine control module driver fault, especially with several high codes medium
- Moisture in the injector connector low
Symptoms
- Check engine lamp on immediately
- Cylinder 6 misfire
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P216F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.