OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P216C

Fuel Injector Group E Supply Voltage Circuit High

P216C is the opposite fault of group E: the feed of the cylinder 5 injector carries voltage when it should not. GM tests it while the high-side driver is switched off; if 1 V or less remains between the signal and the controller supply, the line is treated as shorted to power. Its 2016 3.6 LGX V6 and 2018 6.2 LT4 V8 tables need at least 11 V and count 10 failures out of 20 samples at 100 ms, type A with the MIL on the first trip. Typical sources are a chafed wire touching another powered circuit or an injector winding contacting a live conductor; GM's PI0631H lists this code with dozens of others for the Impala harness that wears on the transmission. Because the injector may stay energised, the module cuts it off and cylinder 5 drops out. P216B is the short to ground.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / 6C

Possible causes

  • Injector 5 feed chafed against a powered circuit high
  • High-side driver in the engine control module leaking voltage medium
  • Moisture or corrosion bridging pins in the injector connector low

Symptoms

  • Check engine lamp on immediately
  • Cylinder 5 misfire and rough idle

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P216C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication