OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P216B

Fuel Injector Group E Supply Voltage Circuit Low

P216B reports the feed of injector group E pulled toward ground. In GM petrol direct injection, group E means the injector of cylinder 5, so the code appears on V6 and V8 engines. GM's 2016 3.6 LGX V6 and 2018 6.2 LT4 V8 tables treat it as the injector 5 high-side line being grounded: while the driver is switched on, 25 A or more flows through it. With at least 11 V, 10 failures out of 20 samples at 100 ms set the code, type A, so the MIL lights on the first trip. GM's preliminary information PI0631H for 2012 and 2013 Impala found the engine harness chafing against a transmission edge, which can ground a single circuit such as this one. The injector is shut off and cylinder 5 drops out. P216A is the general fault, P216C the short to voltage.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / 6B

Possible causes

  • High-side wire of injector 5 chafed through to ground, for example on the transmission high
  • Cylinder 5 injector shorted to its housing medium
  • Engine control module output stage faulty low

Symptoms

  • Check engine lamp on immediately
  • Cylinder 5 misfire, noticeable shaking

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P216B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication