OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2160

Vehicle Speed Sensor B Circuit Low

P2160 reports that speed signal B shows little or no activity although the vehicle is plainly moving. Which pickup carries the letter B is the manufacturer's choice. GM assigns P2160 to the transfer case output speed sensor of its four-wheel-drive models (table 18OBDG04): with a gear engaged, moderate pedal and torque, no braking and the transmission output turning, a raw sensor reading under 25 rpm for 4.5 seconds stores the code as Type B, so the MIL follows after two trips. A broken wire, a short to ground or a dead sensor are the usual reasons. P2161 covers dropouts and erratic readings, P2158/P2159 the circuit and plausibility of the same sensor. Four-wheel-drive and speed-dependent functions may be restricted.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / 60

Possible causes

  • Broken signal wire or short to ground between sensor B and the module high
  • Speed sensor B itself delivers no pulses medium
  • Corroded or pushed-back pins at the sensor connector medium
  • Tone wheel loose or missing after transfer case or driveline work low

Symptoms

  • Check engine lamp after two drives
  • Four-wheel-drive warning or 4WD modes unavailable
  • Speedometer or cruise control misbehaving on some models

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2160

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication