OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P215E

Reductant Heater D Current Too Low

P215E says the fourth DEF heating element, heater D, drew less current than expected while it was switched on, so it is probably not warming the fluid. Which element carries the letter D depends on the maker; many SCR systems stop at three. No maker documents P215E publicly. GM's 2025 Duramax tables and Ford's 2023 diesel summary check only heaters A to C; GM flags their currents below 0.75 A across 40 readings, one per tenth of a second, as Type A; Ford watches power and current during each heating cycle. GM bulletin 21-NA-149 does show a heater D on the 3.0 L LM2, but only with circuit codes P20C5 and P20C8. The usual causes are an open or burnt element, high resistance at the connector or a missing heater feed. P215F is the high-current partner, P20C5 to P20C8 the control-circuit faults. In frost the fluid may thaw late.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / 5E

Possible causes

  • Heating element D open or burnt through, often inside a heated line or pump assembly high
  • Corroded or loose pins at the heater D connector limiting current medium
  • Heater feed fuse or relay open, so the element gets no voltage medium
  • Weak heater output stage in the engine or DEF control module low

Symptoms

  • Check engine light together with a DEF or emission system message
  • Dosing starts late or not at all after cold starts in frost
  • Restart countdown or speed limitation if the fault stays active

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P215E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication