OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2150

Fuel Injector Group B Supply Voltage Circuit Low

P2150 reports the common feed of injector group B shorted toward ground. In GM's 2018 Duramax tables group 2 holds injectors 2 and 3 on the 2.8 L four-cylinder but injectors 2 and 5 on the 6.6 L V8; the test is the same as for group A – 0.5 Ω or less to ground with the driver on, 5 failed samples out of 10, type A with lamp on the first trip. Ford's 2023 diesels flag a short of group B to ground or battery, detected by the driver chip in roughly 0.2 s. GM petrol direct injection, documented for the Saab 9-5 2.0T, uses P2150 for low voltage on the high-side control line of cylinder 2. Because both injectors of a diesel bank lose their feed, the engine runs on fewer cylinders. P2149 is the open circuit, P2151 the high fault of this group.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / 50

Possible causes

  • Group B supply wire chafed and shorted to ground high
  • Injector of group B shorted to its body medium
  • Moisture in the injector harness connector medium
  • Faulty injector driver in the engine control module low

Symptoms

  • Two cylinders misfire together
  • Marked power loss and vibration
  • Check engine lamp on immediately

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2150

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication