P214D
SCR NOx Catalyst Outlet Temperature Too High During Particulate Filter Regeneration
P214D sets when the temperature behind the SCR catalyst exceeds its limit while the particulate filter is regenerating. It is the only code of this group with public manufacturer evidence. Ram pickups with the 6.7L Cummins use it: bulletin 18-053-14 (2014 Ram 2500/3500) reprograms the PCM partly to prevent unnecessary MIL events from P214D, and STAR case S2625000004 (2025–2026 Ram 3500 to 5500) groups it with exhaust temperature sensor codes such as P242B and P2470–P2472, asks for a check of battery voltage first and stresses identifying each sensor by name. That points to sensor faults and calibration as frequent causes, besides genuine overheating from hydrocarbons burning on the hot SCR during regeneration. P214B is the inlet counterpart.
Possible causes
- Exhaust temperature sensor behind the SCR faulty, confused with another sensor or affected by low battery voltage high
- PCM software requiring an update (Ram 6.7L bulletins) medium
- Regeneration fuel slipping through and burning on the SCR medium
Symptoms
- Check engine light on
- Regeneration aborted or repeated
- Additional exhaust temperature sensor codes
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P214D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.