OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2147

Fuel Injector Group A Supply Voltage Circuit Low

P2147 means the common feed of injector group A is pulled toward ground. GM documents it in detail for its 2018 Duramax diesels: the high-side line to injectors 1 and 4 (group 1 on both the 2.8 L four and the 6.6 L V8) shows 0.5 Ω or less to ground while the driver is switched on; with the engine running and more than 11 V, 5 failures in 10 samples at 100 ms set it, type A, lamp on the first trip (2025 tables: 4 of 8). Ford's 2023 diesels report a short of group A to ground or battery found by the driver chip after about 0.2 s. On GM petrol direct injection such as the Saab 9-5 2.0T the code stands for low voltage on the high-side control line of cylinder 1. Both injectors of the group usually stop, so two cylinders drop out. P2148 is the opposite fault.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / 47

Possible causes

  • Injector supply wire chafed and shorted to ground high
  • Injector of the group shorted internally to its body medium
  • Water in the injector harness connector medium
  • Faulty injector driver in the engine control module low

Symptoms

  • Two cylinders misfire at once
  • Heavy loss of power, rough running
  • Check engine lamp on immediately

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2147

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication