OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2144

EGR Vent Control Circuit Low

P2144 reports a low signal in the circuit that drives the EGR vent solenoid – the valve that bleeds vacuum from a vacuum-operated EGR valve so it can close. With the usual low-side switching, a control wire touching ground keeps the solenoid energised regardless of the command. Whether that leaves the EGR valve unable to open or unable to close depends on the plumbing, but in both cases the EGR rate can no longer be controlled. Ford's 2014 spark-ignition code list includes P2144 with the warning lamp and a continuous test, though Ford gives no threshold; no other public manufacturer document names the code. P2143 covers an open circuit and P2145 the high fault of the same solenoid. Typical results are rough running, higher NOx or a failed EGR readiness test.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / 44

Possible causes

  • Control wire chafed through and shorted to ground high
  • Internal short in the vent solenoid coil medium
  • Corrosion bridging terminals in the connector medium
  • Faulty output stage in the engine control module low

Symptoms

  • Check engine lamp on
  • Rough idle or hesitation
  • Emissions test failure because of EGR

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P2144

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication