P2141
EGR Throttle Control Circuit A Low
P2141 flags a low signal in the drive circuit of EGR throttle A, the main diesel regulating flap that lowers intake pressure so exhaust gas can flow back. A wire of the flap motor touching ground, a winding shorted to the housing or a wet connector are the common reasons. Note how J2012 spreads flap A over two ranges: open circuit and range/performance sit at P0487 and P0488, low and high at P2141 and P2142; flap B uses P213A to P213D. P0489 sounds similar but concerns the EGR valve A drive, not the throttle. No manufacturer documents P2141 publicly, so no figures can be quoted; CARB requires circuit faults on output components to be reported. The module usually disables the flap, which then rests open, and EGR is reduced.
Possible causes
- Chafed wire shorting to ground between module and flap high
- Moisture or corrosion in the flap connector medium
- Actuator motor winding shorted to housing medium
- Faulty output stage in the engine control module low
Symptoms
- Check engine lamp on
- Engine shudder when switched off
- Reduced power or limp mode
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2141
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.