P213D
EGR Throttle Control Circuit B High
P213D is the opposite electrical fault to P213C on EGR throttle B: the drive line carries voltage where the output stage expects ground, or the driver measures excessive current. A wire touching battery positive, a shorted motor winding that pulls too much current, or a mechanically blocked flap that overloads the motor are the usual triggers. The output stage switches off to protect itself, so the flap returns to its spring position and stops regulating. No manufacturer publishes thresholds for P213D; CARB requires output circuits to be checked for faults in both directions. Throttle A reports the same high condition as P2142, while P213A covers an open circuit and P213B a flap that moves but misses its target. Drivers notice the warning lamp, sometimes reduced power.
Possible causes
- Drive wire shorted to battery voltage high
- Shorted turns in the actuator motor causing overcurrent medium
- Flap mechanically blocked, motor overloaded medium
- Faulty output stage in the engine control module low
Symptoms
- Check engine lamp on
- Reduced power in some operating ranges
- EGR readiness not completed
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P213D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.