OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P213C

EGR Throttle Control Circuit B Low

P213C points to a low signal in the drive circuit of EGR throttle B: the output stage sees too little voltage where it expects supply potential, which almost always means a conductor of the flap motor is touching ground. Chafed harness sections near the exhaust, water in the connector or a motor winding shorted to its housing are typical. Depending on the bridge design the module either switches the output off or the motor stays partly energised. No manufacturer documents this code publicly, so no threshold or debounce time can be given; CARB demands separate detection of circuit faults on output components. For throttle A the matching short-circuit code is P2141. An open circuit on B is P213A, a function fault P213B. The flap usually falls back to its rest position and EGR is limited.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / 3C

Possible causes

  • Chafed wire shorting to ground between module and flap high
  • Water or corrosion in the flap connector medium
  • Actuator motor winding shorted to housing medium
  • Faulty output stage in the engine control module low

Symptoms

  • Check engine lamp on
  • Reduced power or limp mode
  • Engine shudder when switched off

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P213C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication