OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P213A

EGR Throttle Control Circuit B/Open

P213A concerns the electrical drive of EGR throttle B, a second motor-driven regulating flap found on some diesel layouts. Such a flap closes partly so that pressure ahead of the intake falls below exhaust pressure and enough exhaust gas can be recirculated; it also cuts air at engine stop. The engine module watches the output stage of flap B and stores P213A when the circuit is open or the driver flags a fault it cannot assign to low or high. No manufacturer documents this code publicly, so thresholds are unknown; CARB treats the flap as an output component whose circuit must be monitored. Flap A reports the same fault as P0487. Expect the flap to rest in its spring position, reduced EGR and possibly a power limit.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / 3A

Possible causes

  • Loose, corroded or broken connector or wire at throttle B high
  • Open winding in the throttle B actuator motor medium
  • Harness damaged by heat near the exhaust or EGR cooler low
  • Faulty output stage in the engine control module low

Symptoms

  • Check engine lamp on
  • Reduced power or limp mode
  • Engine shudder when switched off
  • EGR readiness not completed

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P213A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication