P2132
Throttle/Pedal Position Sensor/Switch F Circuit Low
P2132 sets when signal F drops below its lower voltage limit. Ford uses it for the third accelerator pedal track of its second-generation electronic throttle: its 2012 OBD summary treats anything under 0.25 V as a continuity fault and lights only the wrench lamp, not the MIL. FCA's emissions recall T21 for the 2004-2006 Dodge Sprinter lists P2132 among the codes that may appear after the engine control unit is reprogrammed. GM's TACM trucks of 2004-2005 fold low readings of sensor 3 into the general code P2130. Likely causes are a short to ground on the F signal, an open 5 V feed or wear at the closed end of the track. P2133 is the high fault on F, P2122 and P2127 the low faults on tracks D and E.
Possible causes
- Signal wire of track F shorted to ground high
- Open or weak 5 V reference to the pedal sensor medium
- Track F worn at the rest position medium
Symptoms
- Wrench or engine warning lamp on
- Delayed or rate-limited acceleration
- Idle may stay raised until the brake is pressed
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P2132
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.