OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P212E

Throttle Position Sensor/Switch G Circuit Intermittent

P212E is reserved for brief dropouts or spikes on throttle position signal G, the kind that clear again before a steady low or high fault can be confirmed. No manufacturer documents this code publicly. GM, which assigns G to sensor 2 of the bank 2 throttle body on a twin-throttle engine, reacts to such glitches with its range checks instead: P212C below 0.195 V and P212D above 4.805 V each need only 0.14 s. CARB requires input sensors to be monitored for circuit faults, which is the duty this slot covers. In practice the trigger is a loose terminal, a chafed wire near the engine or moisture in the connector. Check the harness while flexing it with the engine running. The fault may vanish between workshop visits.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / 2E

Possible causes

  • Loose or worn terminal at the bank 2 throttle connector high
  • Harness chafed by engine movement, breaking contact now and then medium
  • Moisture or corrosion in the connector medium
  • Momentary contact loss on the sensor track low

Symptoms

  • Warning lamp that comes and goes
  • Brief stumbles or power dips
  • Fault often not present at the workshop

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P212E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication