OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P212C

Throttle Position Sensor/Switch G Circuit Low

P212C sets when position signal G reads below its lower electrical limit. The letter G only comes into play on engines with more than one electronic throttle. GM's 2023 and 2024 OBD tables (23OBDG07, 24OBDG07) give it to the second position sensor in the bank 2 throttle body of a twin-throttle engine: a raw voltage under 0.195 V lasting 0.14 s while the ECU is running stores the code within one trip. Usual culprits are a signal wire shorted to ground, a lost 5 V feed to that throttle body or a damaged sensor track. P212D is the matching high fault, P212A the general circuit code, P212B the plausibility check of G. Once a bank 2 signal is lost, the ECU typically restricts power.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / 2C

Possible causes

  • Signal wire of sensor G shorted to ground high
  • 5 V reference to the bank 2 throttle body open or pulled low medium
  • Worn or damaged track of position sensor G inside the throttle body medium
  • Corroded or loose terminals at the bank 2 throttle connector low

Symptoms

  • Engine warning lamp on
  • Reduced engine power message
  • Uneven idle or hesitation on one bank

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P212C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication