OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P212A

Throttle Position Sensor/Switch G Circuit

P212A is the general circuit code for throttle position signal G, a letter that only comes into play on engines with more than one electronic throttle or extra position tracks. No manufacturer documents P212A publicly. GM's 2023 table 23OBDG07 assigns G to the second position sensor of the bank 2 throttle body on a twin-throttle engine, but reports its electrical faults through the separate codes P212C (below 0.195 V) and P212D (above 4.805 V), each after 0.14 s in one trip. CARB requires input components like this to be checked for circuit faults, and P212A is the catch-all slot for that duty. Check the connector, wiring and 5 V supply at the second throttle body. P212B covers plausibility, P212C-P212E low, high and intermittent faults.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / 2A

Possible causes

  • Open or short in the sensor G signal, supply or ground wire high
  • Corroded or loose connector at the throttle body medium
  • Failed position sensor inside the throttle body medium

Symptoms

  • Engine warning lamp on
  • Reduced power or limp mode
  • Rough idle on twin-throttle engines

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P212A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication