P2129
Throttle/Pedal Position Sensor/Switch E Circuit Intermittent
P2129 is meant for short dropouts or spikes in signal circuit E that do not last long enough for a steady low or high fault. No manufacturer documents this code publicly. GM and Ford, which assign E to the second pedal sensor, catch such glitches inside their circuit codes instead: GM counts failures every 12.5 ms and flags the APP sensor 2 circuit after 19 of 39 counts (P2125/P2127/P2128), Ford uses 0.25/4.75 V limits. CARB requires circuit monitoring of input sensors; the code fits that duty. Check for loose pins and harness chafing with the pedal moved slowly. Effects range from a warning lamp to brief power cuts while driving.
Possible causes
- Loose terminal or poor pin tension at the pedal connector high
- Chafed harness making intermittent contact medium
- Worn spot or cracked joint inside the pedal sensor medium
Symptoms
- Warning lamp that comes and goes
- Brief hesitation or power loss while driving
- Reduced power mode after repeated dropouts
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2129
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.