OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2128

Throttle/Pedal Position Sensor/Switch E Circuit High

P2128 sets when pedal track E reads above its upper limit, typically from an open sensor ground, a short to 5 V or a broken track. Where E is a half-scale signal the limit lies far below the supply: GM's 2006 tables flag sensor 2 above 2.295 V and the 2014 VW Passat above 2.43 V. Pedals with two full-scale tracks use about 4.75 V (Ford, GM 2007, 19 of 39 counts) or 4.824 V for 0.2 s (GM's Bosch-based 2012 ECM). Since both tracks often share one ground, an open ground can set P2128 together with P2123. With E rejected the ECU steers on track D only and limits output; Ford's 2020-2023 summary lights MIL and wrench lamp. P2127 is the low fault on E, P2123 the high fault on D, P2138 the D/E comparison.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / 28

Possible causes

  • Open or high-resistance ground of the pedal sensor high
  • Track E signal shorted to the 5 V reference medium
  • Broken track or solder joint inside the pedal sensor medium

Symptoms

  • Engine warning lamp and reduced power message
  • Weak acceleration even with the pedal fully pressed
  • Often stored together with P2123 if the ground is open

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P2128

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication