OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2127

Throttle/Pedal Position Sensor/Switch E Circuit Low

P2127 reports that pedal track E reads below its lower limit. Because many pedals run the second track at roughly half the voltage of the first, the limit for E can sit lower than for D: GM's 2006 tables flag sensor 2 under 0.1625 V and the 2014 VW Passat under 0.27 V, against 0.61 V for track D. Full-scale designs use similar limits on both tracks: Ford 0.25 V, GM's 2023 table 0.28 V for 0.2 s, GM's Bosch-based 2012 ECM 0.625 V. Typical causes are a short to ground on the E signal wire, an open reference feed, or a worn spot at the closed end of the track. With E gone the ECU relies on track D alone and holds back torque. P2128 is the high fault on E, P2122 the low fault on D, P2125 the general E circuit code.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / 27

Possible causes

  • Track E signal wire shorted to ground high
  • Open 5 V reference feed for the second track medium
  • Worn track E at the closed-pedal end medium
  • Corroded or loose pedal connector low

Symptoms

  • Engine warning lamp, on newer Fords together with the wrench lamp
  • Reduced power and slower pedal response
  • Traction control may be switched off

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P2127

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication