P2126
Throttle/Pedal Position Sensor/Switch E Circuit Range/Performance
Signal E is electrically intact but its value does not fit the situation. Ford's 2012 OBD summary uses P2126 for the second pedal sensor on Gen2 throttle systems: it sets when sensors D and E disagree by more than 1.1 degrees, as a non-MIL fault with the wrench lamp. Mitsubishi lists P2126 as accelerator pedal sensor E on the 2022 Outlander. Many newer systems report the same disagreement as P2138 instead. P2125 is the general circuit fault, P2127/P2128 are voltage below or above limits, P2129 covers dropouts. The vehicle usually stays drivable with softened pedal response; on Ford the MIL stays off and only the wrench lamp lights.
Possible causes
- Worn or dirty sensor track E giving offset readings high
- Contact resistance at the pedal connector medium
- Shared reference or ground circuit shifting one signal low
Symptoms
- Wrench or engine warning lamp on
- Softened or delayed acceleration
- Idle may be raised when braking
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P2126
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.