P2125
Throttle/Pedal Position Sensor/Switch E Circuit
P2125 reports a general electrical fault in signal circuit E. GM uses it as Accelerator Pedal Position Sensor 2 Circuit: the ECM looks for a continuous or intermittent open or short in the sensor 2 circuit with a counter at 12.5 ms per count (19 of 39 counts). In GM's 2006 tables sensor 2 is valid between about 0.16 and 2.3 V. GM bulletin 14636 lists P2125 among the pedal codes caused by a broken solder joint inside the pedal (2009-2011 Impala, LaCrosse). Range/Performance is P2126, explicit low or high voltage P2127/P2128, dropouts P2129, and the D/E comparison P2138. With one pedal track lost the ECU usually limits engine power.
Possible causes
- Internal fault in the pedal sensor (e.g. cracked solder joint) high
- Open or short in the sensor 2 wiring or 5 V reference medium
- Loose or corroded pedal or inline connector medium
- ECM input fault low
Symptoms
- Engine warning lamp and reduced power message
- Delayed or limited pedal response
- Traction control may be switched off
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P2125
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.