P211E
Throttle Actuator B Control Module Processor
P211E is the processor fault for the control of throttle B on engines with two electronic throttles. No manufacturer documents this code publicly. The A version P2107 is well described: Ford treats it as an internal processor fault or lost link to the main CPU, detected in 60 ms, with MIL and an ETC lamp, and from 2024 reports it under P2108. Twin-throttle systems published by GM and Ford drive both throttles from the one engine computer and do not show a separate P211E. CARB requires on-board computers and their outputs to be monitored. If it appears, check ECU supply, grounds and software level before replacing hardware. Expect limp mode. Module performance for B is P211F.
Possible causes
- Control unit software fault (reflash) high
- Voltage dips or poor ground at the control unit medium
- Internal hardware failure of the control unit low
Symptoms
- Engine and ETC warning lamps on
- Limp mode with reduced power
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P211E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.